Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive - Air-Cooled (A Frame) - Manual (Page 170)

4-16 Commissioning
7000A-RM001A-EN-P – January 2011 7000 “A” Frame
Drive Application Review
In order to ensure trouble free commissioning, it is necessary for all
involved in the start-up to familiarize themselves with the drive line-
up and application. Service on the equipment should not be
performed without a clear understanding of how the equipment has
been designed to function and how the equipment has been applied.
If questions arise that have not been addressed within this manual,
they can be addressed by contacting your local GMS office or by
contacting Medium Voltage Support directly.
Rockwell Automation Drive Line-up Drawings
Prior to performing any service work on the drive line-up, the
electrical and dimensional drawings provided with the equipment
must be studied and understood. Within these drawings is detailed
information and instructions required for commissioning and
installation of the equipment including the following:
Dimensional Drawings
Power cable termination locations
Ground bus locations
Shipping split locations
Control and medium voltage power ratings
Drive options
Remote I/O protocol
PLC options
Motor and load specifications
Drive power component selection ratings
Heat exchanger ratings, connections
Electrical Drawings
Contactor locations (electrically)
Drive topology
General notes
Cable isolation ratings
Symbol table
Component designations
Device
Designations
Color Designations
Wire No.
Designations
SGCT
Designations
Ribbon Cable
Designations
Location of Relay
and Contactor
Contacts
Location of
Relays
Drawing Location
References
Customer power and control wiring locations (electrically)
Control and medium voltage power ratings
Fuse ratings and locations (electrically)