Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive - Air-Cooled (A Frame) - Manual (Page 150)

3-76 Operator Interface
7000A-RM001A-EN-P – January 2011 7000 “A” Frame
Example
As an example of using the chart, we will modify a parameter while
displaying it, starting from the Top Level Menu referred to in the
chart as the MAINMENU screen. This example assumes you have
read the previous sections of this manual. The example will
concentrate more on the flow of screens and how it relates to the
chart, rather then the actual operations being performed by each
screen. The symbols refer to those of the chart. Descriptions of
movement, i.e. lateral, refer to flow depicted on the chart.
Displaying the MAINMENU, press the [F4] key. The DISPLAY
GROUP screen is now shown. Cursor to a parameter group and
press the [enter] key. This laterally moves us to the DISPLAY
screen. Since you selected a parameter group, pressing the [F7] key
takes us into a selection operation (symbol 'D') in which the
SELECT screen is displayed. This allows us to use the cursor keys
to select the desired parameter.
Pressing the [enter] key laterally moves us to the symbol T which
ends the selection process. For this example, the symbol T laterally
moves to the symbol M that defines a new process in which the
selected parameter can be modified. The MODIFY PARAMETER
screen is now displayed.
To change the parameter, you must have the proper access to it. If
required press the [F8] key to display the ACCESS screen, as
represented by the symbol P. Obtain the access from this screen and
press [F10] to exit. This will return you to the MODIFY
PARAMETER screen. When you are finished with this screen, press
[F10] exit and you will be returned to the SELECT screen (via
symbols M and T). Pressing [F10] again will return you to the
DISPLAY screen (via the symbol D). Successive presses of the
[F10] key will return you to the DISPLAY GROUP and finally to
either the MAINMENU or the MESSAGE screens.
If you have changed any data in the drive, the [F10] Exit key will
bring up the MESSAGE screen. The message will remind you that
the changes made in the drive are only temporary, unless saved to
NVRAM. If you desire the data to be temporary, press [F9] 'No' and
you will continue onto the MAINMENU. If you press [F8] 'Yes', the
NVRAM screen is entered, from which you can save the data.
Exiting the NVRAM screen returns you to the MAINMENU.
Pressing the [F10] Exit key on the MESSAGE screen will return you
to the DISPLAY GROUP screen.