Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive - Air-Cooled (A Frame) - Manual (Page 137)

Operator Interface 3-63
7000 “A” Frame 7000A-RM001A-EN-P – January 2011
Select a Filename
When working with existing files on the flash card, it is necessary to
pick a file from the directory in order to use in the operation being
performed. When the DIRECTORY screen is entered, all files that
are relevant to the operation are displayed. The [cursor up] and
[cursor down] keys are then used to select the desired file. Pressing
[Enter] will select the file and proceed with the operation.
Press the [F10] key to abort the selection operation and return to the
previous screen without continuing with the operation.
Enter a Filename
When a new file is being created, the DIRECTORY screen is used to
enter the new filename. Upon entering the screen all existing files
relevant to the operation are shown as shown in Figure 3.90.
Figure 3.90 – Typical File Selection
An existing filename can be used as a basis for the new filename by
first selecting that filename. Press the [F2] key. The filename can
now be edited. Refer to the section entitled “Edit Text” for further
details. When complete, pressing the [Enter] key will proceed with
the operation.
Firmware is the program that is run in the operator interface to
provide all the functionality described in this manual. Firmware is
loaded from the flash card in one of two ways.
a) If an operator interface has a memory card inserted when it is
powered up or rebooted, and that card has a valid firmware file
with the extension of .FMW, the operator interface will
automatically load the first .FMW file it encounters on the card.
b) The user can select from one or more .FMW files on the card and
load the selected firmware into the operator interface. This is the
method that will be described here.
Loading Programs
(Firmware)