Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive - Air-Cooled (A Frame) - Manual (Page 345)

Component Definition and Maintenance 5-103
7000 “A” Frame 7000A-RM001A-EN-P – January 2011
To save to the Operator Interface Terminal and Flash Card, Press F2
(UTILITY), F7 (TRANSFER), and F4 (PARAMETERS). You should
now be on the following screen:
In order to save parameters to the Operator Interface Terminal, press F5
(DRV>MEM). To save to the Flash Card, you must first insert the card in
the terminal. Remove the back cover and insert the card in the slot on the
terminal. It can only go in one way. Then press F4 (DRV>CRD).
Saving to the card means that you will have to choose a file name. Use
the Up and Down arrows to select the character, and then use the Right
arrow to go to the next character. Press the Enter key when finished.
Press F8 for YES, and the parameters will be transferred to the card.
Press F10 to EXIT.
Here is a typical pin out of a complete null-modem cable. Essentially,
only 3 pins (2, 3 and 5) are all that is required.