Rockwell Automation 8720MC Drives Integration Manual - Manual (Page 68)

Publication 8720MC-IN002A-EN-P — December 2002
3-14 Troubleshooting Your 8720MC Servo Drive
Parameter 716 - SCANport Logic Mask
This parameter may be used to prevent any SCANport device from
controlling the drive. The structure of parameter 716 is as follows:
If a bit is set true (1) the device interface is enabled.
Bit 0: Digital I/O - “I/O”
Bit 1: Port control 1 - “Port Cntrl 1”
Bit 2: Port control 2 - “Port Cntrl 2”
Bit 3: Port control 3 - “Port Cntrl 3”
Bit 4: Port control 4 - “Port Cntrl 4”
Bit 5: Port control 5 - “Port Cntrl 5”
Bit 6: Port control 6 - “Port Cntrl 6”
For the location of the DPI/SCANport connector, refer to Figure 1.2 in
Chapter 1.