Rockwell Automation 8720MC Drives Integration Manual - Manual (Page 79)

Publication 8720MC-IN002A-EN-P — December 2002
SCANport Command Interface 4-5
Jog Request - If the drive is stopped (disabled via bit 00 of the
command word) and the jog command bit is set true (rising edge) and
there are no faults, the drive will assert the jog reference enabled state
and follow SCANport jog reference command on SCANport adapter
Input Word 2.
The drive will continue to follow the jog reference until the jog is
released. It will then regenerate to a stop.
The manual reference request, bit 11 of the SCANport Logic Command
Word, does not need to be asserted. This will automatically occur
when the jog bit 02 is set.
Fault Clear - If a drive shut down fault has occurred setting the
Drive_Err_Reset bit is required in order to reset the drive shut down
error. The fault cannot be reset unless the fault condition is removed.
Coast Stop Request - If the drive is running and the Coast Stop
Request bit is set the drive power will be removed from the motor and
it will not regenerate. Under this condition the motor will coast until
the friction of the motor and load bring it to a stop.
Refer to the tables below for SCANport I/O key logic commands.
SCANport Input Command Word SCANport Output Status Word
Bit Description Bit Description
00 Regenerative Stop Request 00 Drive Enabled
01 Start Request 01 Auto Reference Enabled
02 Jog Request 02 Rotation Direction
03 Fault Clear 03 Drive OK
04 Coast Stop Request 04 At Zero Speed
05 Parameter Set Select bit 0 05 At Reference Speed
06 Parameter Set Select bit 1 06 Orient complete
07 Parameter Set Select bit 2 07 Reserved
08 Parameter Strobe 08 Brake Solenoid enabled
09 Orient Request 09 Torque greater than Torque Limit
10 Home Request 10 High Winding Selected
11 Manual Reference Select 11 Low Winding Selected
12 Reserved 12 Shut Down Fault
13 Reserved 13 Reserved
14 Reserved 14 Reserved
15 Reserved 15 Manual Reference Selected