Rockwell Automation 8720MC Drives Integration Manual - Manual (Page 71)

Publication 8720MC-IN002A-EN-P — December 2002
Troubleshooting Your 8720MC Servo Drive 3-17
Changing Parameters Using the DPI HIM
When using the HIM to monitor or change parameters, use the up and
down arrows (
∧∧∧∧ and ∨∨∨∨) to arrive at selections. Refer to the instructions
that came with your HIM for more information.
To monitor or change parameters using the DPI HIM:
1. Select Parameter from main menu. Press
↵ ↵↵ ↵
.
2. Select parameter number. Press
↵ ↵↵ ↵
.
3. Enter new value. Press
↵ ↵↵ ↵
.
Changing Parameters Using the SCANport HIM
When using the HIM to monitor or change parameters, use the up and
down arrows (
∧∧∧∧ and ∨∨∨∨) to arrive at selections. Refer to the instructions
that came with your HIM for more information.
To monitor or change parameters using the SCANport HIM:
1. Press ESC.
2. Select Program. Press
↵ ↵↵ ↵
.
3. Select Servo Loop. Press
↵ ↵↵ ↵
.
4. Select Linear List. Press
↵ ↵↵ ↵
.
5. Select parameter number. Press
↵ ↵↵ ↵
.
6. Press Sel.
7. Enter new value. Press
↵ ↵↵ ↵
.