Comtech EF Data CDD-562L - Manual (Page 118)

CDD-562L/564 Demodulator with IP Module Revision 2
CDD-56X CLI and Telnet Operation MN/CDD564L.IOM
8–14
8.2.2.6 SNMP Configuration page
Access the SNMP Configuration page from the Administration page.
Use this page to specify management parameters for Simple Network Management Protocol. This
page contains the following unique selections/fields:
Selection Entry Description
SNMP Read Community R (GET community) Allows GET operations to all portions of the
demodulator Controller and Quad Demodulator MIBs.
SNMP Write Community W (SET community string) Allows SET operations to all portions of
the demodulator Controller and Quad Demodulator MIBs.
SNMP Trap Community T Defines Community String that will be set in the Community
field of all outgoing traps. This field on the trap PDU may be
checked by the network manager application to determine if the
trap came from a “trusted” agent.
SNMP Trap Destination #1 D IP address where all traps/notifications will be sent. If a network
management application is running in the network, it should be
configured to receive traps and its IP address should be
entered here. Supports 2 – Trap Destinations.
SNMP Trap Destination #2 2 IP address where all traps/notifications will be sent. If a network
management application is running in the network, it should be
configured to receive traps and its IP address should be
entered here. Supports 2 – Trap Destinations.
SNMP Trap Version V Determines whether an SNMPv1 trap or SNMPv2 notification is
sent.
SNMP Enable Authentication
Trap
A Determines whether a MIB2 authentication trap will be sent
when a PDU with an invalid community string is encountered. A
community string is invalid when it does not match the Admin,
the Read Write, or the Read Only community strings.
SNMP System Contact C User-defined SNMP Contact information.
SNMP System Name N User-defined SNMP Name information.