Comtech EF Data CDD-562L - Manual (Page 91)

CDD-562L/564 Demodulator with IP Module Revision 2
Ethernet-based Remote Product Management MN/CDD564L.IOM
6–11
6.5.1.2 Navigation
This manual uses a naming format for all web pages to indicate the depth of navigation needed to
view the referenced page: “Top Level Tab | Page Hyperlink”
For example: “Home | Support” is interpreted to mean “first click the top-level ‘Home’
navigation tab; then, click the ‘Support’ page hyperlink.
Roll the cursor over the navigation tabs located at the top of each
page, and then select from the available page hyperlink. You can
fully monitor and control operations of the CDD-56X from the
HTTP Interface. Roll the cursor over the navigation tabs located at
the top of each page (shown at right) to select from the available
nested hyperlinks.
For further details on using the Web Server Interface, see Chapter 9. HTTP (WEB SERVER)
INTERFACE.
6.5.1.3 Page Sections
Each web page is divided into operational content sections.
Whether there is one section to a page, or there are multiple
sections, the title at the upper-left corner of each page or page
section provides a reference to its operational features.
This manual explains the purpose and operation for each web page on a per-page, per-section
basis.
6.5.1.4 Execution Buttons
Configuration changes generally do not take effect until a selection has been
saved to Flash memory. There may be anywhere from one execution button per
page up to multiple execution buttons within a page section. The label for each
of these buttons is generally self-explanatory, e.g., [Submit], [Refresh], etc.
All execution buttons serve the same purpose – to save the configuration changes to Flash
memory, or to execute an update of the active page display.
Always make sure to click the execution button before selecting another web
page. Any changes made on that previous page will not be saved if the
execution button for those functions is not clicked.
6.5.1.5 Feature Selection
Drop-down menus provide access to multiple setting selections, where available,
for a specific function. Move the cursor to the drop-down tab, and then left-click
the tab. The drop-down will open and list the available selections. Move the cursor
to the desired choice and then left-click once again to select that choice.