Comtech EF Data CDD-562L - Manual (Page 84)

CDD-562L/564 Demodulator with IP Module Revision 2
Ethernet-based Remote Product Management MN/CDD564L.IOM
6–4
6.3.4 MIB-II
The demodulator agent implements RFC 1213, Management Information Base for Network
Management of TCP/IP-based Internets. This is known as “MIB-II” or “Public MIB support.”
For detailed OID information please see the actual MIB file. The agent implements the
following Groups:
Table 6-1. MIB-II Support
Group Comments
System Group Mandatory for RFC1213
Interface Mandatory for RFC1213
IP Mandatory for RFC1213
ICMP Mandatory for RFC1213
TCP Mandatory for RFC1213
UDP Mandatory for RFC1213
SNMP Mandatory for RFC1213
Address Translation Group Implemented but depreciated in MIB-II
EGP Not applicable
6.3.5 Private MIB
The Private MIB holds all the security, feature selection, IP related parameters and all the
demodulator specific parameters. For detailed OID information please see the actual MIB file.
6.3.5.1 Administration Group
This group contains system security, administration, and feature configuration parameters.
6.3.5.1.1 Access Lists Subgroup
This subgroup allows the user to define which remote clients can connect to a demodulator when
the Access List Enforcement is enabled. Each entry allows the user to specify an IP address and a
subnet mask to define a unique class of clients that are allowed access to the unit.
6.3.5.1.2 Features Subgroup
This subgroup allows the user to enable/disable a Standard or FAST feature.
Standard features (ping reply, telnet, , IGMP, and multicast forwarding) can be enabled or disabled
by sending a 1 (enable) or 0 (disable).
Header decompression can be enabled or disabled on a per demodulator basis via the FeaturesTable.
Changing the Working mode between Point-to-Point Mode, Small Network Mode,
Large Network Mode, and Vipersat Mode forces the system to reboot. System
configuration will be saved before re-booting. Please make sure you are setting
the correct value.