Comtech EF Data CDD-562L - Manual (Page 48)

CDD-562L/564 Demodulator with IP Module Revision 2
Rear Panel Connections MN/CDD564L.IOM
3–2
3.2 CDD-56X Cable Connections
Table 3-1. Rear Panel External Cable Connections
Sect.
Service
Type
Connector Name
Connector Type
Connector
Function CDD-562L
(L-Band)
CDD-564
(70/140 MHz)
CDD-564L
(L-Band)
3.2.1 Rx IF
Rx 1 (Rx A on
CDD-564L)
Type ’N’ female BNC female Type ’N’ female
RF Input
Rx 2 (Rx B on
CDD-564L)
Type ’N’ female BNC female Type ’N’ female
Rx 3 (Rx C on
CDD-564L)
N/A BNC female Type ’N’ female
Rx 4 (Rx D on
CDD-564L)
N/A BNC female Type ’N’ female
3.2.2
Terrestrial
Data
10/100 Ethernet RJ-45 female
Ethernet Traffic and
M&C
3.2.3 Utility
Remote Control 9-pin Type ‘D’ male
NOT FOR
CUSTOMER USE
Remote Interface for
Factory Test
Console RJ-11 female
Async Serial Console
Port
The European EMC Directive (EN55022, EN50082-1) requires using properly shielded cables for DATA
I/O. These cables must be double-shielded from end-to-end, ensuring a continuous ground shield.