Comtech EF Data CDD-562L - Manual (Page 58)

CDD-562L/564 Demodulator with IP Module Revision 2
IP Module Ethernet Interface MN/CDD564L.IOM
4–2
• IGMP support for Multicast
• Static IP routing for unicast and multicast
• Symmetric and/or asymmetric operation for maximum bandwidth efficiency
• Point-to-Point or Point-to-Multipoint configuration
• Interoperable with the CDM-570/570L with IP Module, CDM-IP550, and CDM-IP 300L
4.1.2 10/100 BaseT Ethernet Interface
In Router Mode operation, the 10/100BaseT Ethernet Interface is used for routing IP traffic
received over the satellite to another device on the local LAN, and for monitor and control
purposes.
4.1.3 Powerful Network Management
Local or remote management of all demodulator and IP Module functions is available via SNMP,
Telnet, or HTTP. The demodulator may be configured, operated and monitored using any of the
following methods:
User Interface Connection
Demod
Functions
IP MODULE
Functions
Manual
Reference
SNMP
Local or remote – Ethernet via 10/100
BaseT Traffic interface
ALL ALL Chapter 6
Telnet
Local or remote – Ethernet via 10/100
BaseT Traffic interface
ALL ALL Chapter 6
Serial Command Line
Interface (CLI)
Local – Serial RS-232 via Console Port ALL ALL Chapter 8
Web Server
Local or remote – Ethernet via 10/100
BaseT Traffic interface
ALL ALL Chapter 9
4.1.4 Remote Firmware Update via FTP
Chapter 5. UPDATING FIRMWARE
The CDD-56X Satellite Demodulator with IP Module uses flash memory technology internally.
Firmware update archive files may be downloaded from the Internet to a user PC (from Comtech
EF Data’s website), or obtained through Comtech EF Data Customer Support via e-mail or on CD
by standard mail delivery.
Once acquired from Comtech EF Data, new firmware can be uploaded from the user PC by File
Transfer Protocol (FTP) without opening the unit or having to be in the same physical location.