Comtech EF Data CDD-562L - Manual (Page 199)

CDD-562L/564 Demodulator with IP Module Revision 2
HTTP (Web Server) Interface MN/CDD564L.IOM
9–39
o Save Parameters to Flash – When changes are made to the demodulator’s
parameters, the ‘Maint | Save’ page must be selected in order for these settings to be
valid through a power cycle. Without using this option, settings will revert back to
their previous state as indicated by the last time changes were saved to Flash
memory.
o Load Parameters from Flash – Reloads the parameters from Flash memory. This
may overwrite changes that have not yet been saved to Flash memory.
o Restore Factory Defaults – Uses the internal, hard-coded factory default
parameters.
Restoring the factory default configuration requires a system reboot.
Codecast
Set the Codecast Multicast Address used to upgrade the Software Packages using Vload.
Click [Submit] to execute the updates made on this page.
9.3.6.3 Maint | Save
Figure 9-30. Maint | Save page
Clicking the ‘Maint | Save’hyperlink causes all configuration changes made during this
operational session to the demodulator and IP parameters to be stored to Flash memory. These
updates are permanent until the user either initiates and saves a new round of settings updates, or
restores all settings to the original factory defaults via the ‘Maint | Operations’ page.
Any changes made to the demodulators will be lost upon reset or power loss
unless the changes are saved to permanent storage. This applies to all of the
demodulator and IP parameters.
Press the Backspace key ([Back Å]) on the keyboard, or select any other page tab or hyperlink,
to continue using the HTTP Interface.