Comtech EF Data CDD-562L - Manual (Page 95)

CDD-562L/564 Demodulator with IP Module Revision 2
Quick Start Guide MN/CDD564L.IOM
7–3
7.2.3 Transmit and Receive IF Configuration
Step Task
1 Configure the transmit and receive IF parameters for CDM-IP 1, CDM-IP 2, and the CDD-56X
Demod 3 via the modem front panel.
The IF parameters can also be set via Command Line Interface (CLI), Telnet,
Web interface, or SNMP, but for this exercise it is recommended that the modem
front panel be used.
2 Set the TxPower to minimum level.
3
Before proceeding to next step, make sure that CDM-IP 1 is appropriately carrier-locked to
CDM-IP 2, and that CDM-IP 2 is carrier-locked to CDD-56X Demod 3.
7.2.4 Serial Console Port Command Line Interface (CLI) Configuration
Step Task
1 Launch the terminal emulation program (e.g., HyperTerminal, Tera Term, etc.) via Microsoft
Windows.
2 Select the appropriate COM port (i.e., the port to which the DB-9 end of the console cable is
connected) and configure it for:
 38,400 bps
 8 data bits
 No parity
 1 stop bit
 No hardware flow control
3 Press Enter to first log onto, then bring up the CLI Main Menu as depicted in Figure 7-1 via
either the Telnet or HyperTerminal interfaces.
To use the CLI, select the appropriate submenu or command entry by typing the character
indicated at the right. For either interface, enter [X] to return to the previous menu.
To save any CDM-IP configuration changes: From any menu screen, type [S]
(Save Parameters to permanent storage), and then type [y] to confirm save.