Comtech EF Data CDD-562L - Manual (Page 83)

CDD-562L/564 Demodulator with IP Module Revision 2
Ethernet-based Remote Product Management MN/CDD564L.IOM
6–3
1. For proper SNMP operation, the CDD-56X MIB files must be used with the
associated version of the demodulator M&C. See the CDD-562L/ 564/564L
FW Release Notes for information on the required FW/SW compatibility.
2. Maximum number of characters for community strings shall not exceed 20. All
printable ASCII characters, except ’\’ and ‘~’ are allowed. No trailing spaces
are permitted for community strings.
3. Any changes made to the IP Parameters will be lost if the demodulator is
reset or loses power unless the changes are saved to permanent storage.
The IP Parameters can be saved by a SET of the cdd564SaveParamToFlash
OID within the MIB.
6.3.3 SNMP Traps
The CDD-56X supports both SNMPv1 traps and SNMPv2 notifications. The demodulator has
the ability to send out SNMP traps when certain events occur in the demodulator. Which style of
traps the demodulator sends can be configured by the user using the cdd564SNMPTrapVersion
OID. These include unit faults, Rx faults, and LNB faults. A trap is sent both when a fault occurs
and is cleared.
The following MIB-II v1traps/v2 notifications are supported by the CDD-56X:
MIB-II SNMPv1 traps:
Cold Start 1
Link Up 4
Authentication Failure 5
MIB-II SNMPv2 notifications:
Cold Start 1.3.6.1.6.3.1.1.5.1
Link Up 1.3.6.1.6.3.1.1.5.4
Authentication Failure 1.3.6.1.6.3.1.1.5.5
The following Alarms and Faults v1 traps / v2 notifications are supported by the CDD-56X:
Alarms and Faults SNMPv1 traps:
cdd564UnitAlarmTrap 6247251
cdd564RxAlarmTrap 6247252
cdd564LNBAlarmTrap 6247253
Alarms and Faults SNMPv2 notifications:
cdd564UnitAlarmNotification 1.3.6.1.4.1.6247.24.2.0.1
cdd564RxAlarmNotification 1.3.6.1.4.1.6247.24.2.0.2
cdd564LNBAlarmNotification 1.3.6.1.4.1.6247.24.2.0.3