Disabling the dgaf function, Configuring network management parameters – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 786
765
2.
On the page that appears, configure the automatic network discovery parameters.
3.
Click Apply.
To configure AP venue information:
1.
Select AP > AP Setup from the navigation tree.
2.
Click the
icon for the target AP.
3.
On the page that appears, expand the Advanced Setup area.
4.
In the AP Venue List area, configure AP venue information.
Figure 794 Configuring AP venue information
5.
Click Add.
6.
Click Apply.
Disabling the DGAF function
When the DGAF function is enabled for an AP, the AP forwards all downstream wireless broadcast ARP
packets and wireless multicast packets. To prevent spoofing attacks by using downstream multicasts, you
can disable the DGAF function for the AP.
To avoid packet loss, H3C recommends that you enable proxy ARP and multicast optimization before
disabling this function.
Configuring network management parameters
1.
Click the
icon for the target Hotspot2.0 policy.
Figure 795 Configuring network management parameters
2.
On the page that appears, configure the network management parameters as shown in
.
3.
Click Apply.