H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 820)

799
Figure 843 AP information page on AC 2
Band navigation configuration example
Network requirements
As shown in Figure 565 , Client 1 through Client 4 try to associate with AP 1, and the two radios of AP
1 operate at 5 GHz and 2.4 GHz, respectively. Client 1, Client 2, and Client 3 are dual-band clients,
and Client 4 is a single-band (2.4 GHz) client. Configure band navigation to direct clients to different
radios of the AP.
Figure 844 Network diagram
Configuring the AC
To enable band navigation to operate correctly, make sure of the following:
• The fast association function is disabled. By default, the fast association function is disabled.
• Band navigation is enabled for the AP. By default, band navigation is enabled for the AP.
1. Create an AP:
a. Select AP > AP Setup from the navigation tree.
b. Click New.
c. On the page that appears, enter the AP name ap 1, select the model WA3628i-AGN, select
Manual from the Serial ID list, and enter the AP serial ID in the field.
d. Click Apply.
2. Configure wireless service:
a. Select Wireless Service > Access Service from the navigation tree.