Yaskawa i80M Connecting Manual User Manual
Page 158
Advertising
(2) Tap Cycle Signal
The tap cycle signal
output is generated within 8 ms after the tap
cycle
starts.
The tap cycle signal can be turned off by canned cycle block cancellation.
CANCELED)
I
I
Fig. 20.18 Time Chart of G80S
Tapping (TAP) Output
With these outputs the control informs that tapping is being performed during the execution of
part program in the automatic operation mode These outputs are given when tapping starts from
point R to point Z and turned off when tapping from point Z to point R is completed.
I
\\
\
DEN
D E N
M05 M04
Note : M05 can be
–
by parameter
F I N
FIN
FIN
I
TAP
SSP
M03 : SPINDLE FORWARD
SRV
I
M04 : SPINDLE FORWARD
M05 : SPINDLE STOP
Fig. 20.19 Time Chart of G74
158
Advertising