Yaskawa i80M Connecting Manual User Manual
Page 266
21. 3.2.5 HIGH-SPEED REWIND/START INPUT (RWDli #30412)
When the completion signal (FIN) is returned with this input closed during M30 execution,
the NC initiates high-speed rewinding.
(2) When rewinding is completed, automatic startup can be initiated by parameter selection
(#6023
(3) This input is effective in the MEM mode only.
(4) When this input is used, the RWD and EOP inputs are disregarded.
MF OUTPUT
[
I
I
I
I
I
STL
!
t2
1 OOms
Fig. 21.12
High-speed Rewind/Start input
Time Chart
21. 3.2.6 M/T CODE INPUTS AND OUTPUTS (MAO-MA9, MOOR, MOIR, M02R, M30R,
MB9,
MDO-MD9, MEO-ME9, TO-T9, MFA-MFE,
TF,
FIN)
(1)
Code Outputs and
Code Reading Outputs
Table 20.15
M code output
MAO to MA9
#35200 to # 35211
S code output
to
S28
#36540 to # 36567
T code output
TO
to
T19
# 3 5 3 0 0
# 35323
-
B code output
to
#35330 to # 35347
M code reading output
# 35350
S code reading output
SF
#36517
T code reading output
# 35357
B code
reading output
B F
# 35355
These”
-
outputs are for the M and T commands designated by a part program when it is ex-
ecuted in the automatic operation mode.
When the M or T command is encountered during
automatic operation mode part program execution, the control generates BIN code outputs in
accordance with the numerical value subsequent to the M or T command (M :3 digits; T: 2 or 3
digits).
When the time preset by parameter # 5410 has elapsed, the control generates the M/T code
reading signal output.
266