TA Triumph-Adler 6555i - Manual (Page 119)

3-15
Preparation before Use > Energy Saver function
Sleep and Auto Sleep
Sleep
To enter Sleep, press the [ Power ] key. Touch panel and all indicators on the operation panel will go out to save a
maximum amount of power except the Main Power indicator. This status is referred to as Sleep.
If print data is received during Sleep, the print job is performed while the touch panel remains unlit.
When using the optional fax, received fax data is printed out while the operation panel also remains unlit.
• Press the touch panel or any key on the operation panel.
The machine will be ready to operate within 30 seconds.
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time in the Low Power Mode.
The default preset time is 60 minutes.
To change the preset sleep time, refer to
Sleep Timer on page 8-55 .
Sleep Rules (models for Europe)
You can set whether sleep mode operates for each function. When the machine enters sleep mode, it cannot perform
printing from a computer connected by USB cable. In addition, it takes longer for the machine to wake and return to
normal operation. Also, the ID card cannot be recognized.
For more information on Sleep Rules settings, refer to Sleep Rules (models for Europe) on page 8-55 .
Sleep Level (Energy Saver) (models except for Europe)
This mode reduces power consumption even more than normal Sleep mode, and allows Sleep Mode to be set
separately for each function. Printing from a computer connected with a USB cable is not available while the machine is
asleep. The time required for the machine to wake up from power save mode and resume normal operation will be
longer than for normal Sleep Mode.
For more information on Energy Saver Mode settings, refer to Sleep Level (models except for Europe) on page 8-56 .
Energy Saver Recovery Level
This machine can reduce power consumption when recovering from Energy Saver Mode.
For EnergySaver RecoveryLevel, "Full Recovery", "Normal Recovery" or "Power Saving Recovery" can be selected.
The factory default is "Normal Recovery".
For more information on Energy Saver Mode settings, refer to EnergySaver RecoveryLevel on page 8-56 .
NOTE
If the optional network interface kit is installed, Energy Saver cannot be specified.
Main Power
indicator