TA Triumph-Adler DC 2116 - Manual (Page 137)

Other Features of this Fax
5-41
5 Proceed to the procedure for the desired communication.
A. Standard Transmission
(Continued from step 5)
6 Make sure that Send is selected in the message
display.
If it is NOT selected, press the S key or the T key to
select it.
7 Press the Enter key.
8 Press the S key or the T key to select whether or not
you want to designate a time for the transmission to
begin.
> If you want to designate a time for the transmission to begin, select On and proceed to step 9.
> If you want to have the transmission begin immediately after the program key is pressed, select
Off and proceed to step 11.
9 Press the Enter key.
10 Use the keypad to enter the desired time for the
transmission to begin.
If you want to reset the displayed time to “00:00”,
simply press the Stop/Clear key.
11 Press the Enter key.
12 Use the keypad to enter a destination fax number.
You can enter the fax number using the keypad,
abbreviated numbers, one-touch keys, chain dial keys
or the directory. If you enter the fax number using an
abbreviated number or one-touch key that is already
designated for Subaddress-based Communication, you can skip steps 13 through 16.
13 If you want to designate this communication as a Subaddress-based Transmission, press the
Sub-Address key.
> If you pressed the Sub-Address key, proceed to step 14.
> If you DID NOT press the Sub-Address key, proceed to step 17.
14 Enter the subaddress you want to use for this
Subaddress-based Transmission.
The subaddress can be up to 20 digits in length and
can include any combination of the numerals 0 – 9.
15 Press the Enter key.
A. Standard Transmission This page
B. Broadcast Transmission P5-42
C. Polling Reception P5-44
Program key:02:Select Mode
Send
Broadcast
RX Polling
On
Off
Delayed Comm.:
TX Time:12:34
Enter TX Time
:
Enter Fax No.
Subaddress:
Enter Subaddress
20 Digits