TA Triumph-Adler DC 2116 - Manual (Page 172)

Various Settings and Registration
7-2
Note If you want to cancel the procedure part way through, press the Reset key. The operation panel will
return to the initial mode settings.
1 Press the System Menu key.
2 Press the T key to select Fax Default.
3 Press the Enter key.
4 Press the S key or the T key to select Print
Report.
5 Press the Enter key.
6 Press the S key or the T key to select which report to
set.
The following example is for setting the Delayed
Communication Report.
7 Press the Enter key.
8 Press the S key or the T key to select whether or not
you want that report to be automatically printed out.
The asterisk (*) in the message display indicates the
current setting.
If you want the report to be printed out automatically,
select On.
If you selected TX Transaction or RX Transaction in step 4, it will also be possible to select
Output only be Condition here. In this case, the corresponding report will only be printed out
under those conditions that are explained under the information for that report as shown on the left
side of this page.
9 Press the Enter key. The setting for that report is complete.
> If you want to continue the setting procedure for other reports, repeat steps 6 – 9.
> If you want to perform other setting procedures, select End and then press the Enter key.
> If you are finished making settings, press the Reset key. The operation panel will return to the
initial mode settings.
Printer Default
Machine Default
System Menu / Counter
Fax Default
Fax Default:
Line Type
TTI
Print Report
:Tone Dial
:Outside P.
Print Report:
TX Transaction
RX Transaction
Delayed Comm.
:Condition :Condition
:Off
:On
Delayed Comm. Report:
On
Off
*