TA Triumph-Adler DC 2116 User Manual
Page 93
Troubleshooting
4-3
Memory Full.
The memory has reached its capacity while scanning in documents. Press
the Enter key and then select Yes if you want to transmit those documents
that have already been completely scanned. If you want to completely
cancel the transmission, press the S key or the T key to select No and
then press the Enter key.
•
If you do not press the Enter key within a certain amount of time, the
Auto Clear function will engage and all corresponding data will be
erased from memory.
•
In order to transmit all of the documents after you have completely
canceled the operation, try transmission procedure again after
memory becomes available or after you create available space in
memory.
Call for Service.
Maintenance by qualified service personnel is required. Contact your
service representative, an authorized service center or the place of
purchase.
If C and a 3-digit number are displayed as well, inform the service
personnel of the displayed number.
-
Time for maintenance.
Maintenance by qualified service personnel is required. Contact your
service representative, an authorized service center or the place of
purchase.
-
Communication Error.
An error has occurred during a fax transmission or fax reception. Check
the error code – which indicates the origin of the error – on the
corresponding Transmission Report (or Reception Report) that is printed
out after the error.
Continue TX.
[Continue transmission.]
This message will appear in response to pressing the Stop/Clear key
while the Alternate Display key is held down during a communication to
multiple destinations, such as Broadcast Transmission or Polling
Reception.
•
Press the S key or the T key to select Yes if you want to continue the
current operation. However, the individual communication in progress
at the time the Stop/Clear key was pressed will be canceled.
•
Press the S key or the T key to select No if you want to cancel the
communication to all remaining destinations.
-
Original is too long.
[Original sheet is too
long.]
You attempted to use the Document Processor to transmit a document that
was over 63" [1600mm] in length. Press the Enter key to eject the
documents remaining in the document processor. The operation panel will
return to the initial mode settings.
Message
Procedure
Page