TA Triumph-Adler DC 2116 - Manual (Page 207)

Reference Information
10-7
Error Code Tables
When a communications error occurs, one of the following error codes will be printed out on the
corresponding Transmission Report or Reception Report as well as the Activity Report.
Note If an error occurs during communication at a transmission speed of 33600 bps, the “U” in the error
codes noted below will change to an “E”
.
CODE CAUSE AND/OR PROCEDURE FOR CORRECTION
Busy The line is busy or the other party does not answer after automatically redialling the
set number of times. Perform transmission or reception procedures again.
Stopped Transmission has been interrupted by pressing the Stop/Clear key.
Reception has been interrupted by pressing the Stop/Clear key.
During multiple communication (Polling Reception, etc.), this unit was unable to
transmit to all destinations due to a communications interruption.
U00300 The destination fax has run out of recording paper. Check with the destination
party.
U00420 -
U00462 Connection was made on a call initiated by the transmitting party, but the
transmission has been interrupted because the transmitting party does not
possess the necessary communication capabilities.
U00600 -
U00690 Communication was interrupted due to trouble with your unit. Perform transmission
or reception procedures again.
U00700 Communication was interrupted due to trouble with the other party’s fax unit.
Check with the other party.
U00800
U00810 Unsuccessfully transmitted page(s) remain. Perform transmission procedures
again.
U00900
U00910 Unsuccessfully received page(s) remain. Perform reception procedures again.
U01000 -
U01092 A communication error occurred during transmission. Perform transmission
procedures again.
U01100 -
U01199 A communication error occurred during reception. Perform reception procedures
again.
U01400 A communication which uses the timer was scheduled, and a number was entered
using an abbreviated number or one-touch key, etc., but communication with that
party was impossible because that number was no longer registered when the
scheduled time arrived. Check your unit.
U01500 A communication error occurred during transmission at high transmission speed.
Perform transmission procedures again.
U01600 A communication error occurred during reception at high transmission speed.
Perform reception procedures again after having the transmitting party lower the
transmission speed.
U01700
U01720 A communication error occurred during transmission at high transmission speed.
Perform transmission procedures again.
U01721 A communication error occurred during transmission at high transmission speed.
The destination party’s fax may not have the corresponding high speed reception
capabilities. If the destination party’s fax number was dialled using an abbreviated
number or one-touch key, change the transmission speed registered for that
number to a lower setting and perform transmission procedures again.
U01800 -
U01820 A communication error occurred during reception at high transmission speed.
Perform reception procedures again after having the transmitting party lower the
transmission speed.
U01821 A communication error occurred during reception at high transmission speed. Your
unit may not have the corresponding high speed reception capabilities. Perform
reception procedures again after having the transmitting party lower the
transmission speed.