TA Triumph-Adler DC 2116 - Manual (Page 21)

Fax Operation (Names of Parts / Preparations / Features and Functions of this Fax)
1-7
Preparations
When using the fax functions of this machine for the first time after purchasing your Fax System,
perform the procedures as explained in "Designating the Type of Phone Line Being Used ("Line
Type" setting)" through "Setting the Current Date And Time ("Date & Time" setting)".
Note If your service representative performs these settings during set-up of your Fax System, there is no
further need for you to perform these procedures.
Designating the Type of Phone Line Being Used ("Line Type" setting) (Inch version only)
Set the type of phone line here to correspond to the type of telephone service that you are using. BE
SURE the type of phone line you select here is correct because, if the setting is incorrect, dialing –
and therefore fax communication – will be impossible.
Notes • Prior to operation, check the message display to make sure that the touch panel is in the initial
mode for fax operation. (See What is the “Initial Mode”? on page 1-13.)
• If you want to cancel the procedure part way through, press the Reset key. The operation panel
will return to the initial mode settings.
1 Press the System Menu key.
2 Press the T key to select Fax Default.
3 Press the Enter key.
4 Make sure that Line Type is selected in the message
display and press the Enter key.
The asterisk (*) in the message display indicates the
current setting.
5 Press the S key or the T key to select the type of
phone line that you are using.
Select between Tone(DTMF) Line and
Pulse(10PPS) Line.
6 Press the Enter key. The Setting for the type of phone line is completed.
7 Press the S key or the T key to select End and press the Enter key. To finish the setting and turn
to the initial mode settings, press the Reset key.
Printer Default
Machine Default
System Menu / Counter
Fax Default
Fax Default:
End
Line Type
TTI
:Tone Dial
:Outside P.
Line Type:
Tone(DTMF) Line
Pulse(10PPS) Line
*