Roland SPD-SX PRO Sampling Pad with 32GB Internal Memory - Manual (Page 153)

Effect List
153
Tape Echo
A virtual tape echo that produces a realistic tape delay sound. This simulates the tape echo section of a Roland RE-201 Space Echo.
Parameter Value Explanation
Mode
S, M, L, S+M, S+L, M+L,
S+M+L
Combination of playback heads to use
Select from three different heads with different delay times.
S: Short
M: Middle
L: Long
Repeat Rate
0–127 Tape speed
Increasing this value will shorten the spacing of the delayed sounds.
Intensity 0–127 Amount of delay repeats
Bass -15–+15 [dB] Boost/cut for the lower range of the echo sound
Treble -15–+15 [dB] Boost/cut for the upper range of the echo sound
Head S Pan L64–63R Independent panning for the short, middle, and long playback heads
Head M Pan L64–63R
Head L Pan L64–63R
Tape
Distortion
0–5 Amount of tape-dependent distortion to be added
This simulates the slight tonal changes that can be detected by signal-analysis
equipment.
Increasing this value will increase the distortion.
W/F Rate
0–127 Speed of wow/flutter (complex variation in pitch caused by tape wear and
rotational irregularity)
W/F Depth 0–127 Depth of wow/flutter
Echo Level (*1) 0–127 Volume of the echo sound
Direct Level 0–127 Volume of the original sound
Level 0–127 Output Level
*1: This parameter corresponds to MFX Ctrl. For details, refer to “ Controlling the MFX with the PAD EDIT [1] [2] Knobs (MFX
Ctrl) (P.198)”.
*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to “ Controlling the MASTER EFFECT with the MASTER
EFFECT Knob (MASTER EFFECT CTRL) (P.199)”.