Roland SPD-SX PRO Sampling Pad with 32GB Internal Memory - Manual (Page 187)

Effect List
187
Guitar Amp Simulator
This is an effect that simulates the sound of a guitar amplifier.
Parameter Value Explanation
Amp Sw OFF, ON Turns the amp switch on/off.
Amp Type
Type of guitar amp
JC-120 This models the sound of the Roland JC-120.
CLEAN TWIN This models a Fender Twin Reverb.
MATCH DRIVE
This models the sound input to left input on a Matchless D/C-30.
A simulation of the latest tube amp widely used in styles from blues and rock.
BG LEAD
This models the lead sound of the MESA/Boogie combo amp.
The sound of a tube amp typical of the late ‘70s to ‘80s.
MS1959I
This models the sound input to Input I on a Marshall 1959.
This is a trebly sound suited to hard rock.
MS1959II This models the sound input to Input II on a Marshall 1959.
MS1959I+II
This models the sound of connecting inputs I and II on a Marshall 1959 in parallel.
lt creates a sound with a stronger low end than MS1959I.
SLDN LEAD This models a Soldano SLO-100. This is the typical sound of the eighties.
METAL 5150 This models the lead channel of a Peavey EVH5150.
METAL LEAD This is distortion sound that is ideal for performances of heavy riffs.
OD-1
This models the sound of the BOSS OD-1.
This produces sweet, mild distortion.
OD-2 TURBO This is the high-gain overdrive sound of the BOSS OD-2.
DISTORTION This gives a basic, traditional distortion sound.
FUZZ A fuzz sound with rich harmonic content.
Amp Volume
(*1) 0–127 Volume and amount of distortion of the amp
Amp Master 0–127 Volume of the entire pre-amp
Amp Gain
LOW, MIDDLE,
HIGH
Amount of pre-amp distortion
Amp Bass 0–127 Tone of the bass/mid/treble frequency range
Amp Middle
Amp Treble
Amp Presence 0–127
Tone for the ultra-high frequency range
Amp Bright
OFF, ON Turning this “On” produces a sharper and brighter sound.
* This parameter applies to the “JC-120”, “CLEAN TWIN”, “MATCH DRIVE”, and “BG
LEAD” Pre Amp Types.
Speaker Sw OFF, ON Determines whether the signal passes through the speaker (ON), or not (OFF).
Speaker Type
Cabinet Diameter (in inches) and number of the
speaker
Microphone
SMALL 1 Small open-back enclosure 10 Dynamic
SMALL 2 Small open-back enclosure 10 Dynamic
MIDDLE Open back enclosure 12 x 1 Dynamic
JC-120 Open back enclosure 12 x 2 Dynamic
BUILT-IN 1 Open back enclosure 12 x 2 Dynamic
BUILT-IN 2 Open back enclosure 12 x 2 Condenser
BUILT-IN 3 Open back enclosure 12 x 2 Condenser
BUILT-IN 4 Open back enclosure 12 x 2 Condenser
BUILT-IN 5 Open back enclosure 12 x 2 Condenser
BG STACK1 Sealed enclosure 12 x 2 Condenser
BG STACK2 Large sealed enclosure 12 x 2 Condenser
MS STACK1 Large sealed enclosure 12 x 4 Condenser
MS STACK2 Large sealed enclosure 12 x 4 Condenser
MTL STACK Large double stack 12 x 4 Condenser