Roland SPD-SX PRO Sampling Pad with 32GB Internal Memory - Manual (Page 163)

Effect List
163
Low Boost
Boosts the volume of the lower range, creating powerful lows.
Parameter Value Explanation
Boost Frequency 50, 56, 63, 71, 80, 90, 100, 112, 125 [Hz] Center frequency at which the lower range will be boosted
Boost Gain (*1) 0–+12 [dB] Gain of the lower range that will be boosted
Boost Width WIDE, MID, NARROW Width of the lower range that will be boosted
Low Gain -15–+15 [dB] Gain of the low range
High Gain -15–+15 [dB] Gain of the high range
Level 0–127 Output Level
*1: This parameter corresponds to MFX Ctrl. For details, refer to “ Controlling the MFX with the PAD EDIT [1] [2] Knobs (MFX
Ctrl) (P.198)”.
*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to “ Controlling the MASTER EFFECT with the MASTER
EFFECT Knob (MASTER EFFECT CTRL) (P.199)”.
Super Filter
This is a filter with an extremely sharp slope. The cutoff frequency can be varied cyclically.
Parameter Value Explanation
Filter Type
LPF, BPF, HPF, NOTCH Type of filter
Frequency range that will pass through each filter
LPF: frequencies below the cutoff
BPF: frequencies in the region of the cutoff
HPF: frequencies above the cutoff
NOTCH: frequencies other than the region of the cutoff
Filter Slope
-12, -24, -36 [dB] Amount of attenuation per octave
-12 dB: Gentle, -24 dB: Steep, -36 dB: Extremely steep
Filter Cutoff (*1)
0–127 Cutoff frequency of the filter
Increasing this value will raise the cutoff frequency.
Filter Resonance
0–100 Filter resonance level
Increasing this value will emphasize the region near the cutoff frequency.
Filter Gain 0–+12 [dB] Amount of boost for the filter output
Modulation Sw OFF, ON On/off switch for cyclic change
Modulation Wave
TRI, SQR, SIN, SAW1, SAW2 How the cutoff frequency will be modulated
TRI: Triangle wave
SQR: Square wave
SIN: Sine wave
SAW1: Sawtooth wave (upward)
SAW2: Sawtooth wave (downward)