Roland SPD-SX PRO Sampling Pad with 32GB Internal Memory - Manual (Page 188)

Effect List
188
Parameter Value Explanation
2-STACK Large double stack 12 x 4 Condenser
3-STACK Large triple stack 12 x 4 Condenser
Mic Setting
1, 2, 3 Adjusts the location of the microphone that is recording the sound of the speaker.
This can be adjusted in three steps, with the microphone becoming more distant in the
order of 1, 2, and 3.
Mic Level 0–127 Volume of the microphone
Direct Level 0–127 Volume of the direct sound
Pan L64–63R Stereo location of the output sound
Level 0–127 Output Level
*1: This parameter corresponds to MFX Ctrl. For details, refer to “ Controlling the MFX with the PAD EDIT [1] [2] Knobs (MFX
Ctrl) (P.198)”.
*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to “ Controlling the MASTER EFFECT with the MASTER
EFFECT Knob (MASTER EFFECT CTRL) (P.199)”.
Compressor
Flattens out high levels and boosts low levels, smoothing out fluctuations in volume.
Parameter Value Explanation
Attack
0–124 Sets the time from when the input exceeds the Threshold until the volume starts being
compressed.
Release
0–124 Adjusts the time after the signal volume falls below the Threshold Level until
compression is no longer applied.
Threshold
(*1)
-60–0 [dB] Adjusts the volume at which compression begins.
Knee
0–30 [dB] This is a function that smooths the onset of compression from the uncompressed state.
It gradually applies compression starting earlier than Threshold.
Higher values produce a smoother transition.
Ratio
1:1, 1.5:1, 2:1, 4:1, 16:1,
INF:1
Compression ratio
Post Gain 0–+18 [dB] Adjusts the output gain.
Level 0–127 Output Level
*1: This parameter corresponds to MFX Ctrl. For details, refer to “ Controlling the MFX with the PAD EDIT [1] [2] Knobs (MFX
Ctrl) (P.198)”.
*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to “ Controlling the MASTER EFFECT with the MASTER
EFFECT Knob (MASTER EFFECT CTRL) (P.199)”.