Mid-side compressor – Roland SPD-SX PRO Sampling Pad with 32GB Internal Memory User Manual

Page 189

Advertising
background image

Effect List

189

Mid-Side Compressor

This effect allows the left/right signals that have similar phase to be adjusted to a different sense of volume than the left/right

signals that have different phase.

Parameter

Value

Explanation

M Comp

Switch

OFF, ON

Switches whether to adjust the sense of volume for left/right input signals that are nearly (or

fully) in phase.

M Attack

0–124

Sets the time from when the input exceeds the Threshold until the volume starts being
compressed.

M Release 0–124

Adjusts the time after the signal volume falls below the Threshold Level until compression is no

longer applied.

M Threshold

(*1)

-60–0 [dB]

Adjusts the volume at which compression begins.

M Knee

0–30 [dB]

This is a function that smooths the onset of compression from the uncompressed state; it

gradually applies compression starting earlier than THRESHOLD. Higher values produce a

smoother transition.

M Ratio

1:1, 1.5:1, 2:1,
4:1, 16:1, INF:1

Compression ratio

M Post Gain 0–+18 [dB]

Adjusts the output gain.

S Comp

Switch

OFF, ON

Switches whether to adjust the sense of volume for left/right input signals whose signals are

considerably out of phase

S Attack

0–124

Sets the time from when the input exceeds the Threshold until the volume starts being

compressed

S Release

0–124

Adjusts the time after the signal volume falls below the Threshold Level until compression is no

longer applied.

S Threshold -60–0 [dB]

Adjusts the volume at which compression begins

S Knee

0–30 [dB]

This is a function that smooths the onset of compression from the uncompressed state; it

gradually applies compression starting earlier than THRESHOLD. Higher values produce a

smoother transition.

S Ratio

1:1, 1.5:1, 2:1,

4:1, 16:1, INF:1

Compression ratio

S Post Gain 0–+18 [dB]

Adjusts the output gain.

Level

0–127

Output Level

*1: This parameter corresponds to MFX Ctrl. For details, refer to

Controlling the MFX with the PAD EDIT [1] [2] Knobs (MFX

Ctrl)

(P.198)”.

*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to

Controlling the MASTER EFFECT with the MASTER

EFFECT Knob (MASTER EFFECT CTRL)

(P.199)”.

Advertising