Roland SPD-SX PRO Sampling Pad with 32GB Internal Memory - Manual (Page 174)

Effect List
174
Parameter Value Explanation
Ø Note (P.197)
Attack 0–127 Speed at which the level changes between steps
Input Sync Sw OFF, ON
Specifies whether an input note will cause the sequence to resume from the first step of the
sequence (ON) or not (OFF).
Input Sync
Threshold
0–127 Volume at which an input note will be detected
Mode
LEGATO,
SLASH
Sets the manner in which the volume changes as one step progresses to the next.
LEGATO: The change in volume from one step’s level to the next remains unaltered. If the level
of a following step is the same as the one preceding it, there is no change in volume.
SLASH: The level is momentarily set to 0 before progressing to the level of the next step.
This change in volume occurs even if the level of the following step is the same as the
preceding step.
Shuffle
0–127 Timing of volume changes in levels for even-numbered steps (step 2, step 4, step 6...).
The higher the value, the later the beat progresses.
Level 0–127 Output Level
*1: This parameter corresponds to MFX Ctrl. For details, refer to “ Controlling the MFX with the PAD EDIT [1] [2] Knobs (MFX
Ctrl) (P.198)”.
*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to “ Controlling the MASTER EFFECT with the MASTER
EFFECT Knob (MASTER EFFECT CTRL) (P.199)”.