Programmable button function priority – Edwards Signaling eFSA250 User Manual
Page 161
Chapter 3: System operation
E-FSA64 and E-FSA250 Technical Reference Manual
149
Function
Description
Disable
The first press disables any number of correlation groups, correlation group
members, or both. The button LED turns on.
The second press enables the same set of correlation groups and correlation
group members and turns off the button LED.
The Disable function operates differently based on the whether you choose
Correlation Groups, Members of Correlation Group, or Both. The default value
is Members.
• If you choose Disable Correlation Group:
An LCD message indicates that Corr Grp xxx is disabled
All outputs (including relay and sounder bases) are turned off and the
disabled correlation group stops operating
Note:
Detector bases that have been activated by their attached sensors
cannot be disabled through group disable operation.
• If you choose Members of Correlation Group:
An LCD message identifies the Disabled members.
Disabling members of a correlation group does not disable relay or
sounder bases.
Active devices cannot be enabled through a programmable button. To
enable these devices, press the Menu button and choose Control>Enable
Device.
• If you choose Both:
The correlation group stops operating and all members are disabled.
An LCD message identifies the Disabled members.
Unlatch
Unlatches all latched outputs system-wide.
Restore
Restores outputs in any number of correlation groups to their normal state.
(Disabled or latched devices must be enabled or unlatched before they can be
restored.)
None
Removes any function associated with the button.
Programmable button function priority
• Operations such as Signal Silence, Auto Signal Silence, and Drill take priority
over Activate, Restore, and Disable.
• Activate, Restore, and Disable take priority over in-suite signal silence.
• A single Restore or Disable takes priority over one or more Activates.
• Restore or Group Disable only affects devices from correlation groups that
have been added to the list for that button.