Edwards Signaling eFSA250 - Manual (Page 176)

Chapter 3: System operation
164 E-FSA64 and E-FSA250 Technical Reference Manual
To activate or restore an output device:
1. Press the Menu button and choose Control.
2. Enter a level one password.
3. Choose Activate/Restore.
4. Choose Device.
5. Choose the loop the device is on.
Note: If the panel only has one loop, the loop
selection screen does not display.
6. Enter the device ID for the device that you want to
activate or restore.
7. Press Enter.
8. Press Cancel to return to the previous menu.
— or —
Press the Menu button to exit menu mode.
Main Menu
Reports
Test
Control
Program

Enter Password
0000

Control
Enable/Disable
Activate/Restore

Activate/Restore
Device
Panel NAC

Device
Loop 01<>

Device Activate<>
001
Device 001
Unlatching latched output devices
Latched outputs are devices that are configured to shut down air handlers and
dampers automatically when an alarm activates, and to keep them shut down
until they are manually unlatched and restored. For this reason, devices
configured as latched output devices must be manually unlatched and then
restored.
When outputs have been latched, the panel generates an “Outputs are latched”
event. The unlatch command affects all latched output devices system-wide. You
can assign the Unlatch Outputs command to a programmable key on the front
panel or to one of the following modules: E-ISO, E-IDC1A, E-IDC1B, or E-IDC2B.
To unlatch latched output devices:
1. Press the Unlatch Outputs button on the control panel (if programmed).
— or —
Press the Unlatch Outputs module button (if programmed).