Edwards Signaling eFSA250 - Manual (Page 85)

Chapter 2: Front panel programming
E-FSA64 and E-FSA250 Technical Reference Manual 73
Adding and removing devices from
programmed systems
You can add an additional device or several devices to a system that has already
been programmed without reentering programming mode. Once the device is
installed, the panel signals a trouble active event and indicates on the LCD
screen that there is an unconfigured device. The device can then be
programmed and added to the database.
Notes
• If you are adding more than a few devices, you may want to use the
Incremental programming option that lets you quickly add and label the
devices. See “Performing incremental programming” on page 69.
• You must log on with a level two password to add a device.
Device programming options
Table 24 below describes the options to be set when programming devices.
Table 24: Device options
Device option Description
Zone Select the zone you want to add this device to or select Off if you are not adding
the device to a zone.
Zone
secondary
Select the zone to which you want to add this device (secondary element), or
select Off when you are not adding the device (secondary element) to a zone.
See Table 9 on page 43.
Label Enter a text label for the device (two lines of 20 characters). When you have
finished, select Save.
Correlation
groups
Assigns the device to one or more correlation groups. For more information, see
“What is a correlation group?” on page 32.
Enter the number of the correlation group to which the device is assigned.
Choose Included or Excluded.
• “Included” adds assigns the item to the group.
• “Excluded” removes the item from the group
When you have finished, choose Save.