H3C Technologies H3C Intelligent Management Center - Manual (Page 48)

40
Network module application scenarios
Use the network module in the following scenarios:
• When a data center contains multiple VLANs, configure networks based on the VLANs.
• When a data center is managed by multiple operators with different privileges, divide the data
center into multiple networks and assign correct operators to each network.
• When network resources in a data center are to be assigned to tenants, configure networks for the
tenants with required network resources and operators.
Viewing the network list
1. Click the Resource tab.
2. From the navigation tree, select VAN Connection Manager > Network.
All networks appear in the network list.
The list includes the following parameters:
{
Network Name—Name of the network. Click the name to view its detailed information.
{
VLAN ID—VLAN where the network resides.
{
Max. Connections—Maximum number of connections supported by the network. When the
existing connections reach the maximum number, no more connections can be added to the
network.
{
Description—Descriptive information of the network.
{
Bandwidth Control—Displays a bar to represent the number of connections with bandwidth
control and the total bandwidth rate. Place the cursor over the bar to view the detailed
information. If bandwidth control is not configured for connections, this column is empty.
{
Connection—Displays connection information by a colored bar. Connection types are
represented by different colors: green for deployed connections, red for undeployed
connections, and gray for remaining connections that can be deployed. Place the cursor over
a colored area to view the number of the corresponding connections.
{
Copy—Click the Copy icon to copy the same network configuration as the current network
and create a new network.
{
Modify—Click the Modify icon to modify the network.
{
Delete—Click the Delete icon to delete the network.
3. Click Refresh to view the latest networks.
Querying networks
VCM supports both basic and advanced queries.
Basic query
1. Click the Resource tab.
2. From the navigation tree, select VAN Connection Manager > Network.
All networks appear in the network list.