Minolta PI4700E - Manual (Page 147)

5 Properties settings
5-28 Pi4700e
Pr
in
ter
Dr
iv
er
f
o
r Li
nux
Ch
apte
r 5
Functions of the Detail of Output Setting Dialog Box
Settings can also be made for finishing functions including stapling, hole
punching, and folding.
(1) Staple <when Mailbin Finisher, Single-staple Finisher, Multi-staple Finisher or Fold-
ing Finisher is installed>
This function allows you to staple one set of printed documents at a time.
• Off Printed documents are not stapled.
• Corner Printed documents are stapled at their corners.
• Long Edge <when Multi-staple Finisher or Folding Finisher is in-
stalled>
The documents are stapled along the long edge.
• Short edge <when Multi-staple Finisher or Folding Finisher is in-
stalled>
The documents are stapled along the short edge.
• Center <when Folding Finisher is installed>
The documents are stapled at the center.
(2) Punch <when Mailbin Finisher, Multi-staple Finisher or Folding Finisher is installed>
This function allows you to punch holes in the printed document.
• Off The document is not punched.
• Short Edge The document is punched along the short edge.
• Long Edge The document is punched along the long edge
• Punch Holes
<Inch area only>
Set the number of holes to be punched.
(3) Folding <when Folding Finisher is installed>
Select the desired paper folding function.
• Off Printed pages are not folded.
• Just Output Size [Z-
Fold]
Printed pages are folded into three parts.
• Half Folding Printed pages are folded in two at their center.
• Crease A crease is made in printed pages.
(1) (3)
(2)