Minolta PI4700E - Manual (Page 404)

Setting Up IP Parameters 12
Pi4700e 12-53
A
ppe
ndi
x
Chap
ter
12
12.7 Setting Up IP Parameters
Before you can use TCP/IP for network printing, you must first assign the
following IP parameters to the Network Card: IP address, subnet mask,
default gateway.
You can use any of the following methods for assigning IP parameters to
the Network Card.
Bundled Utility Programs
● Management Access Program (MAP) (Windows) or a Web browser
See “8.7 Using the utility software”
Note that your computer must have IPX/SPX conversion protocol in-
stalled in able to use MAP.
● BOOTP (Windows)
See “8.7 Using the utility software”.
Other Methods
● ARP command (Windows)
See “Assigning IP Addresses Using ARP (For Windows)”.
● ARP command (UNIX)
See “Assigning IP Addresses Using ARP (For UNIX)”.
● BOOTP daemon (UNIX)
See “Assigning IP Addresses Using the BOOTP Daemon (For UNIX)”.
● RARP daemon (UNIX)
See “Assigning IP Addresses Using the RARP Daemon (For UNIX)”.
● DHCP daemon (UNIX)
See “Using the DHCP Daemon (For UNIX)”.
✎
Note
If you start up the Digital Copier with its initial factory default setup
without assigning a Digital Copier IP address, ATIP (Automatic Tem-
porary IP Address) automatically assigns an IP address and subnet
mask. You can use IP address assigned by ATIP to detect the Digital
Copier with the MAP utility. To change the current IP address and sub-
net mask setting, first access the Digital Copier’s Web setup page from
MAP, and then make the changes you want.