Minolta PI4700E - Manual (Page 152)

Properties settings 5
Pi4700e 5-33
Pr
in
ter
Dr
iv
er
f
o
r Li
nux
Ch
apte
r 5
Job Management tab
(1) Account Code
Check this box when using the copy track function. An account code is attached to
each printing job, enabling you to carry out management at the machine. In order to
use this function, copy track function must be set at the machine.
When the copy track function is set at the machine, printing may sometimes fail to
take place until the access number managed at the machine is correctly set.
• Account Code Makes the copy track function valid.
• Access Number Enter the access number set in the machine.
Setting range: 0002 to 9999 (4 digits)
(2) Lock Job
Check this box when locking a printing job.
When using Lock Job, set a password in “Password.”
A locked printing job is printed when it is unlocked using the Job List display on the
panel of the machine. In this case, a password is necessary.
• Lock Job Make the lock job function valid.
• Password Enter the password of the lock job.
Setting range: 0000 to 9999 (4 digits)
(3) Distribution <when Hard Disk Drive in Copier is installed>
Specifies to add a distribution in the background during printing, and also sets the
conditions for adding distribution number.
A distribution number is added for each set of prints.
• Distribution Number Select the distribution number function.
• 1st Page Only Select whether to print the distribution number on only
the first page, or on all pages.
• Starting Number Specify the starting number of the distribution numbers
to be printed.
Setting range: 001 to 999
(1)
(2)
(3)