As/400 – Minolta PI4700E User Manual
Page 386
UNIX Configuration
12
Pi4700e
12-35
A
ppe
ndi
x
Chap
ter
12
5
Type the appropriate Network Card values on the window that ap-
pears.
The following table shows some sample settings.
6
From the three settings at the bottom of the window, select
Remote
Printer is on BSD System
.
7
Click
OK
.
8
Ping the Network Card to check the connection.
ping <Network Card IP address>
When ping causes the message shown below to return, it means the
IP address is setup correctly.
<Network Card IP address> is alive.
AS/400
When working with the output queue description (WORKOUTQD), you
must provide information for a number of fields in order to allow the Net-
work Card to function properly as a remote printer device.
1
When prompted for the remote system, type
INTNETADR
so the AS/
400 system recognizes the device as an IP device.
2
Input an appropriate name (like
PORT1
) for the remote printer queue
name.
3
Connection type
must be
IP
.
4
Internet address
must be the Network Card IP address.
5
Destination Type
must be
OTHER
.
6
In response to the message asking if you want to convert SCS to
ASCII, type
YES
.
This tells the AS/400 system to convert text.
7
For
Manufacturer type and model
, specify the printer driver that
comes with the printer controller.
Item
Example
Input Data Description
Printer Name
myprinter
Name used in the lp command
Remote System Name
fastprint
Network Card host name recorded in
/etc/
hosts
Remote printer Name
PORT1
lpd queue name (You can use any name you
want here.)