Minolta PI4700E - Manual (Page 67)

3 LPR Printing
3-20 Pi4700e
Ne
twor
k
Se
ttin
g
s
Ch
apte
r 3
9 On the Additional Port Information Required page, select Custom ,
and then click Settings .
10 On the Configure Standard TCP/IP Port Monitor dialog box, select
LPR from the LPR Settings box.
11 Type PORT1 in the name of the queue you want into the Queue Name
box, and then check the LPR Byte Counting Enabled check box.
12 Click OK to return to the Additional Port Information Required
page.
13 Click Next to display the next wizard page, and then click Finish .
14 Click the Close button of the Printer Ports dialog box, and then click
the Apply button of the Properties dialog box.
15 Display the General tab, and then print a test page.
16 If the test prints normally, complete the procedure by clicking OK to
close the Properties dialog box.
After you finish installing a printer with the above procedure, you can use
it just as you would any standard local printer. The printer can also be
used as a network printer by other Windows computers on your network
whose Windows 2000/XP systems are configured the same way as de-
scribed above.