Minolta PI4700E - Manual (Page 55)

3 Peer-to-Peer Printing Program (Windows)
3-8 Pi4700e
Ne
twor
k
Se
ttin
g
s
Ch
apte
r 3
3.4 Peer-to-Peer Printing Program (Windows)
Peer-to-Peer Printing Program is a Windows utility that lets you output di-
rectly to a printer from a computer on a network, without going through a
server.
Use this program for peer-to-peer printing under TCP/IP.
Requirements
● Computer must have TCP/IP installed and enabled.
● Network Card must have valid IP parameters assigned.
✎
Note
Refer to the applicable Windows documentation for information about
installing TCP/IP under Windows.
Installing the IP Peer-to-Peer Printing Program
Use the following procedure to install the IP Peer-to-Peer Printing Pro-
gram.
1 Load the CD-ROM into the CD-ROM drive of the computer you want
to use.
2 Start Setup.exe in the lp-p2p folder on the CD-ROM.
3 Follow the instructions that appear on the screen to complete the in-
stallation.
The default installation directory is
C:\Program Files\Ip-p2p . You can
change this to any other directory during the installation procedure.
✎
Note
The message
Use the Add Printer Wizard in the Printer Group to
add new Peer to Peer IP Printers . appears on the screen at the end
of the installation procedure. The installation procedure does every-
thing required to install the program correctly, so simply click
OK to
clear this message.