Minolta PI4700E - Manual (Page 283)

8 Jumper switch setting
8-52 Pi4700e
Netw
or
k
I
n
ter
fa
c
e
Car
d
Chap
ter
8
Address Selection
Either one of two memory address blocks can be used to access the com-
mon memory interface. The two memory address blocks are named
CS1
and CS2 . The CS1 space is used when only one card is being used. Use
jumper switch JP2 to select the address space. Setting the jumper switch
pin to 1-2 selects CS2 , while pin setting 2-3 selects CS1 .
Bus Handshaking
The bus handshake signal can be changed to match the print controller
being used. In the case of this Digital Copier, the handshake signal is the
WAIT signal (
OP3 pin 2 and 3 setting).