Sco unix – Minolta PI4700E User Manual
Page 388
UNIX Configuration
12
Pi4700e
12-37
A
ppe
ndi
x
Chap
ter
12
12
Add any comments you want to the printcap file. For example, you
could type something like the following.
Dick’s printer is down the hall.
13
Select
exit
to save your settings and then press
to complete the
procedure.
SCO UNIX
Use the following procedure to set up a remote printer on the host that
sends jobs to a Network Card using lpd.
1
At the prompt, type:
mkdev rlp
✎
Note
You cannot run mkdev rlp twice. To add another printer, use the rlp-
conf command.
2
Type the responses shown below for the questions that appear.
Do you want to install or remove a remote printer?
Type:
I
3
Do you want to change printer description file /etc/printcap?
Type:
Y
4
Write a printer name.
Type the name of the printer.
Example:
lprprinter1
5
Is lprprinter1 a remote printer or a local printer?
Type:
R
6
Enter remote host name.
Type the Network Card host name recorded in the printcap file.
Example:
lprprinter
7
Confirm the information you have entered.
Type:
Y
8
Confirm the preceding connection as your system default.
Type:
Y
Enter