Minolta PI4700E - Manual (Page 151)

5 Properties settings
5-32 Pi4700e
Pr
in
ter
Dr
iv
er
f
o
r Li
nux
Ch
apte
r 5
✎
Note for (1)
If you select a size of paper not loaded in the machine or Manual Feed,
the machine will give a message prompting you to add paper to Tray1,
Tray2, or Manual Feed and enter into a standby state.
✎
Note for (2)
When using the OHP interleaving function, set the number of sets of
prints to
1 .
✎
Note for (3)
Keep Collate (Sort) on the application side set to
OFF at all times.
✎
Tip for (4)
If you exit prints to the Elevator Tray when the Single-staple Finisher,
Multi-staple Finisher or Mailbin Finisher is installed, the prints are ex-
ited in a sawtooth manner.
When the Folding Finisher is installed or if none of the finishing options
is installed, the prints are exited in a criss-cross manner.
The following are the minimum requirements for permitting criss-cross
sorting using the Collated setting.
Stacks of paper of the same size are loaded in the lengthwise
and crosswise directions.
The Staple, Punch or Cover mode is not set.
✎
Tip for (5)
A Portrait or Landscape print appears on the Page Layout.