Minolta PI4700E - Manual (Page 281)

8 Jumper switch setting
8-50 Pi4700e
Netw
or
k
I
n
ter
fa
c
e
Car
d
Chap
ter
8
8.9 Jumper switch setting
This chapter explains how to change the settings of the Network Card’s
jumper switch settings.
Normally, the Network Card automatically makes network configuration
settings, so you do not need to change jumper switch settings. There may
be certain situations, however, where it becomes necessary to change
jumper switch settings.
✎
Important!
Special care is required when handling the Network Card.
The Network Card is designed to protect components from electrostat-
ic discharge during normal operation. Be sure to take proper electro-
static protection measures whenever handling the Network Card.
Be sure to unplug the Digital Copier from its power outlet before starting
work. For full details on handing the Network Card, see the Setup Instruc-
tions that comes with the Network Card.
Network Card and Jumper Pin Positions
The illustration below shows the positions of the jumper switches on the
Network Card.
* Default pin positions are indicated in gray.
Resetting to Factory Defaults
Jumper switch OP2 can be used to reset all Network Card parameters to
their initial factory default settings. The function of OP2 is to reconfigure