Hp-ux system – Minolta PI4700E User Manual
Page 396
UNIX Configuration
12
Pi4700e
12-45
A
ppe
ndi
x
Chap
ter
12
6
The printcap entries you have made up to this point appear on the dis-
play and the script confirms whether you want the entries written into
the
/etc/printcap
file. Type
yes
if you want the entries added to print-
cap and then press
. If you do not want them added, type
no
,
press
and then manually make the required changes to the en-
tries.
<printer name> | Print Server Card printer:\
:lp=/dev/<printer name>:\
:if=/usr/nic/infilter:\
:sd=/usr/spool/<printer name>:
7
This completes the installation. In response to the message about
whether you want to install another printer, input
yes
or
no
and then
press .
Like all BSD systems, ULTRIX uses the
/etc/printcap
file to configure a
printer. The interface to the installation script is the same for all BSD sys-
tems, but the printcap entry is different.
HP-UX System
1
Type the following command to run the installation script.
nicinst
The script automatically downloads the appropriate Network Card util-
ities for your system and displays questions to prompt you for the in-
formation it needs.
2
What is the node name of the Print Server Unit?
Type the host name recorded in
/etc/hosts
. For example, type
print-
fast
and then press
.
3
What is the printer name?
Type the printer name and press
.
4
Here, the script displays the information you have input up to this point.
Node name of the Print Server Card: printfast
Printer name to be used: <printer name>
The printer is attached on: PORT 1
Check these settings and make sure they are correct. If they are cor-
rect, type
yes
and press
. Otherwise, type
no
and press
.
Enter
Enter
Enter
Enter
Enter
Enter
Enter