Minolta PI4700E - Manual (Page 66)

LPR Printing 3
Pi4700e 3-19
Ne
twor
k
Se
ttin
g
s
Ch
apte
r 3
Configuration Procedure (Windows 2000/XP)
1 Install TCP/IP under Windows 2000/XP.
Refer to the applicable Windows documentation for more information.
2 Assign the IP parameters.
See “3.2 Specifying the IP Address From the Printer’s Touch Panel”
(p. 3-2) for more information.
3 Use the procedure below to install the printer.
Installing the printer (Windows 2000/XP)
1 Install the printer driver following the instructions that come with the in-
staller. Make the new printer the default printer.
2 Right-click the new printer icon and select Properties from the menu.
3 Display the Ports tab.
4 Click Add Port .
This displays a list of available port types.
5 Select Standard TCP/IP Port from the list, and then click New Port .
This starts Add Standard TCP/IP Printer Port Wizard .
6 Click Next on the introduction page of the wizard.
7 On the Add Port page, type the IP address of the Network Card into
the Printer Name or IP Address box.
If the network you are on uses DNS (Domain Name Services), type in
the DNS name instead of the IP address.
8 Type the name of the port you want into the Port Name box, and then
click Next .
✎
Note
When you type the IP address into the
Printer Name or IP Address
box, the name of the port is automatically entered in the Port Name
box as IP_<IP address>, but you can change the port name as you
want.