Minolta PI4700E User Manual
Page 267
8
Using the utility software
8-36
Pi4700e
Netw
or
k
I
n
ter
fa
c
e
Car
d
Chap
ter
8
✎
Note
The above procedure is not registered in the error log when it is per-
formed. Powering the Digital Copier down clears log contents.
Setting Up the Protocol
You can use the
Protocol setup
command to configure non-AppleTalk
network protocols. On the
Option
menu, select
Protocol setup
to display
the dialog box shown below.
You can use the radio buttons on the dialog box to enable and disable pro-
tocols. We recommend that you select
off
for protocols that are not used
on your network.
After enabling TCP/IP, you can set or change IP parameters. Input the val-
ues for your network environment into the
IP Address
,
Subnet Mask
, and
Default Gateway
fields on the dialog box.
✎
Note
Check with your network administrator if you are not sure of the IP pa-
rameter settings you should make for your network environment.
In some cases, the IP parameters all show zeros. This indicates that
IP parameters are not set, it does not indicate the current IP parame-
ters.
1
After making the settings you want, click the
OK
button.
2
To enable the new settings, power the Digital Copier down and then
back up again. You can then check the settings on the status page.