Minolta PI4700E - Manual (Page 258)

Macintosh configuration 8
Pi4700e 8-27
Netw
or
k
I
n
ter
fa
c
e
Car
d
Chap
ter
8
8.6 Macintosh configuration
This chapter describes how to configure for network printing in a Macin-
tosh environment.
Setting Up AppleTalk
Use the following procedure to make AppleTalk settings.
1 On the Apple menu, point to Control Panel and then select Apple-
Talk .
2 Select Ethernet .
3 Close the AppleTalk dialog box.
Selecting and Setting Up the Printer
You must use the following procedure to configure the driver before print-
ing for the first time.
1 Install the PostScript printer driver and the PPD file for the Digital Copi-
er.
❍ See the documentation that comes with the Digital Copier for infor-
mation about how to install it.
2 Select Chooser from the Apple menu.
3 Use the field in the upper left of the dialog box to select the appropriate
printer driver for your Digital Copier.
4 Use the field in the lower left of the dialog box to select the zone where
the Digital Copier is connected.
❍ You do not need to select a zone if your network is configured with-
out using zones.
5 In the printer list on the right side of the dialog box, select your Digital
Copier. The default name of this Digital Copier is MLT_<serial num-
ber>.
6 Click the Create button. (If the dialog box on your screen does not
have a Create button, click the Setup button instead.)