Minolta PI4700E - Manual (Page 54)

Peer-to-Peer Printing with TCP/IP 3
Pi4700e 3-7
Ne
twor
k
Se
ttin
g
s
Ch
apte
r 3
Configuration Procedure (Windows NT 4.0)
1 Install TCP/IP under Windows NT 4.0.
Refer to the applicable Windows documentation for more information.
2 Assign the IP parameters.
See “3.2 Specifying the IP Address From the Printer’s Touch Panel”
(p. 3-2) for more information.
3 Install the IP Peer-to-Peer Printing Program.
Use the IP Peer-to-Peer Printing Program for peer-to-peer printing.
See “3.4 Peer-to-Peer Printing Program (Windows)” (p. 3-8) for more
information.
4 Use the procedure below to install the printer.
Installing the printer (Windows NT 4.0)
1 On the Start menu, point to Settings and then click Printers .
2 Double-click Add Printer and install the printer. Make the new printer
the default printer.
See “2 Installing the Printer Driver” (p. 2-1) for details about how to in-
stall it.
3 Right-click the new printer icon and select Properties from the menu.
4 Display the Ports tab.
5 From the Print to the following port(s) list, select the port where the
Digital Copier IP address is displayed.
6 Click the OK button of the Properties dialog box to close it.
7 Right-click the printer icon again to display its Properties dialog box,
display the
General tab, and then perform a Test Print operation.
8 If the test prints normally, complete the procedure by clicking OK to
close the Properties dialog box.
After you finish installing a printer with the above procedure, you can use
it just as you would any standard local printer. The printer can also be
used as a network printer by other Windows computers on your network
whose Windows NT 4.0 systems are configured the same way as de-
scribed above.